Follow this to enable auto-connect and wifi on any of your BSNL dsl modem cum routers. Mine is DNA-A211-I.
1. Go to the default getway, most likely 192.168.1.1. If you are unable to get to it, feel free to reset the router to the factory setting by a small button at the back of the router.
2. Login using admin/admin, unless you have changed it. (You should!)
3. Go to "Advanced Setup" -> "WAN". Click on the "edit" button on the entry with values 0/35 for VPI/VCI and PPPoE for Protocol.
4. Select service category "UBR without PCR". Click next.
5. Select "PPP over Ethernet (PPPoE)" and Encapsulation Mode as "LLC/SNAP-BRIDGING". Click next.
6. Type username and password for your BSNL connection, "dataone" as service name and "AUTO" as Authentication Method. Check "Dial on Demand" and set 30 minutes (or whatever) as timeout. Check "Retry PPP password on authentication error" and "Bridge PPPoE Frames Between WAN and Local Ports (Default Enabled)". Click next.
7. Check "Enable WAN service". Click next, save and save/reboot.
Source :-http://amitgud.blogspot.in
1. Go to the default getway, most likely 192.168.1.1. If you are unable to get to it, feel free to reset the router to the factory setting by a small button at the back of the router.
2. Login using admin/admin, unless you have changed it. (You should!)
3. Go to "Advanced Setup" -> "WAN". Click on the "edit" button on the entry with values 0/35 for VPI/VCI and PPPoE for Protocol.
4. Select service category "UBR without PCR". Click next.
5. Select "PPP over Ethernet (PPPoE)" and Encapsulation Mode as "LLC/SNAP-BRIDGING". Click next.
6. Type username and password for your BSNL connection, "dataone" as service name and "AUTO" as Authentication Method. Check "Dial on Demand" and set 30 minutes (or whatever) as timeout. Check "Retry PPP password on authentication error" and "Bridge PPPoE Frames Between WAN and Local Ports (Default Enabled)". Click next.
7. Check "Enable WAN service". Click next, save and save/reboot.
Source :-http://amitgud.blogspot.in
